Continued from step 3.

4. Make sure that you have the required type of virtual circuit established for communications across the WAN:
• For Passport 4400 to Passport 4400, an SVC or a PVC can be used.
• For Passport 4400 to Passport 6400, an SPVC is required.
• For Passport 4400 to a FRAD (Annex G), a PVC is required.

Refer to Configure Connections to the Passport Network for further information and procedures.

5. Reset the unit to put the configuration into effect. You can access the System Reset screen either of two ways:
• If you are at the X.25 Service screen, click on the System Reset link at the top of the page.
• If you are anywhere else in the Configurator screens, click on the arrow next to Administration and click on System Reset.

With the System Reset screen displayed, select Configuration for the Reset Type:



Click on the Reset button. After the unit finishes the reset, your browser will automatically be reconnected to the unit and the main Configurator page will be displayed.

End of procedure.