Configuring Call Spreading Using the Configurator

Using the Configurator, the configuration required to implement the routing table in Example of a Call Spreading Application is as follows:

1. Select Configure, WAN/Data Services, and X.25 from the navigation menu:



You will see the X.25 Service screen.

2. Select X.25 Routing (Physical Port) from the Configuration options:



The configuration wizard presents you with a series of screens to complete. When you complete these screens, the physical routing information is configured. The screens presented are (the example screens show Passport 4460 hardware with Port 3 on the base being used for X.25):

• X.25 Port Selection. Select the port from the pull down menu:



• Modify a Packet Level Interface. Complete this form as required by your network.
• Add a X.25 Route (Physical):

Enter an index number for this route and the X.25 address pattern. An asterisk (*) can be used as part of the X.25 address pattern. Click on the Save button.

At this point, the X.25 Service screen is displayed, with the following text indicating that the unit's X.25 configuration has changed and that a reset is required:

3. Do not reset the unit at this time. Repeat step 2 for the second route to the same DNA. Then, go on to step 4.
4. Reset the Passport unit to put the configuration into effect. You can access the System Reset screen either of two ways:
• If you are at the X.25 Service screen, click on the System Reset link at the top of the page.
• If you are anywhere else in the Configurator screens, click on the arrow next to Administration and click on System Reset.
5. With the System Reset screen displayed, select Configuration for the Reset Type:



6. Click on the Reset button. After the Passport unit finishes the reset, your browser will automatically be reconnected to the unit and the main Configurator page will be displayed.

End of procedure.