Adding X.25 Service Connections

To add X.25 service connections, you should follow the X.25 services setup procedure, as described in X.25 Services Setup Using the Configurator. An X.25 service connection is setup in the following order:

• A virtual port is added, if required.
• An LAPB virtual circuit for layer 2 transport is added.
• An X.25 virtual circuit to make the X.25 connection is added.
• A frame relay virtual circuit to carry the new service is added, if required.
• Add the X.25 routing information.
• Add X.25 PVCs, if required.

Adding new connections requires that you reset the unit. This reset is also part of the X.25 services setup procedure.