Configurator Procedure for Voice Level Adjustment
Before you begin, perform the following actions.
- Starting with station 1, insert a VNA between the telephone set and the RJ11 connector of PBX extension 3123.
- At station 2, connect the other VNA between the telephone set and the RJ11 connector of PBX extension 3456.
- Power up the two VNAs, set the SETUP switch on both VNAs temporarily to BRDG, and the other switches to TEST, OFF.
- Pick up the telephone at station 1 and dial the T1/E1 or ISDN trunk access code,
(a PBX defined parameter). You will receive a dial tone from Digital Voice Channel B1.
- Dial the remote DSPs number. You will receive a dial tone from the PBX.
- Dial 3456. The telephone at extension 3456 will ring.
- After the first ring, move the SETUP switch at the station 2 VNA to TERM. The telephone will stop ringing.
- Move the SETUP switch at the station 1 VNA to TONE, and hang up the telephone set.
To perform the voice level adjustments, the following procedures must be completed:
