Go back one pageGo to the next page#Go to this book's Table of ContentsGo to this book's Index#

Configurator Preliminary Procedures (Passport 4460)

Provision the T1/E1 for the desired clock source.

  1. Select Configure, Voice, and T1/E1 Profiles from the navigation window.

    2. You will see the T1/E1 Line 1 Profile window:

  2. At Clock Source, select the desired setting and click save. A "Command Successful" message is displayed.
  3. If required, at the top of the window, click on Line 2 Profile and repeat this procedure for the other expansion port.

Busy out all other DVMs by using the following Configurator procedure:

  1. Select Configure, Voice, and Channels from the navigation window.

    2. You will see the Voice Channels window:

  2. Locate the DVM you want to busy out and click on the number associated with that DVM in the Voice Profile column. You will see the Voice Profile window:

  3. At Busyout Mode, select Forced On.
  4. Repeat this procedure for the other DVM channels to be modified if assigned to a different profile.

End Of Topic

Nortel Networks LogoContact us by email
Go back one pageGo to the next page#Go to this book's Table of ContentsGo to this book's Index