Go back one pageGo to the next page#Go to this book's Table of ContentsGo to this book's Index#

Configurator Preliminary Procedures (Passport 4430/50/55)

  1. Provision the T1/E1 DSX-1/L1 line and system clock source.
  2. Connect DVM channels B1 and B2 to DS0 channels 1 and 2, respectively.
  3. To connect your voice channels to the proper DS0s, select Configure, Voice, and T1/E1 from the navigation window.

    4. You will see the T1/E1 System Configuration window:

  4. At the top of the window, click on Local (or Network) DS0 Connection. You will see the T1/E1 Local (or Network) DS0 Connection window:

  5. Locate the Line and DS0 Index you want to configure and click Modify. You will see the Modifying the Local (or Network) DS0 Connection window:

  6. Select the desired channel to be connected to the DS0. When the desired DS0 connection has been configured, click on Save. A "Command Successful" message is displayed.
  7. At the top of the window, click on...Previous and repeat this procedure for the other DS0 connection to be made.

Busy out all other DVMs by using the following Configurator procedure:

  1. Select Configure, Voice, and Channels from the navigation window.

    2. You will see the Voice Channels window:

  2. Locate the DVM you want to busy out and click on the number associated with that DVM in the Voice Profile column. You will see the Voice Profile window:

  3. At Busyout Mode, select Forced On.
  4. Repeat this procedure for the other DVM channels to be modified if assigned to a different profile.

End Of Topic

Nortel Networks LogoContact us by email
Go back one pageGo to the next page#Go to this book's Table of ContentsGo to this book's Index