Configurator Adjustment Procedure for Single Line Telephone Application

Use the test setup shown in the figure below. Initially, set both Voice Network Analyzers to BRDG, TEST, and OFF.

• Lift the No.1 telephone set off-hook. Dial extension 456. The No.2 telephone set will ring.
• Place the SETUP switch on the No.2 Voice Network Analyzer to TERM. The telephone will stop ringing.
• Place the SETUP switch on the No.1 Voice Network Analyzer to TONE, and disconnect the No.1 telephone from the Voice Network Analyzer.
• Display the Voice Status, using the following procedures:
• Display the Voice Status(Passport 4430/50/55)
• Display the Voice Status (Passport 4460)