Go back one pageGo to the next page#Go to this book's Table of ContentsGo to this book's Index#

Configure the Output Level Attenuation

  1. Access the Output Level Attenuation parameter of the voice profile associated with the B1. In this example it is assumed that the profile number for both B1 and B2 is 1. To do that, select Configure, Voice, and Channels from the navigation window.

    2. You will see the Voice Channels window:

  2. At Voice Profiles(Common Parameters), use the pull-down menu to select the desired profile to modify and click Modify. You will see the Voice Profile window:

  3. Depending on the reading recorded on the station 2 VNA, change the Output Level Attenuation accordingly.
  4. Use the setting obtained in step 3 to set the output level of all other digital voice channels in your installation as required.
  5. Restore the busyout mode of all DVMs to System Controlled for all voice/fax channels provisioned in the preliminary procedure.
Nortel Networks LogoContact us by email
Go back one pageGo to the next page#Go to this book's Table of ContentsGo to this book's Index