Displaying the Line Parameters

The show t1e1 lineParameters subcommand is used to display the profile selected for the T1/E1 line.

Use the entry option to view the status of either the DSX-1/L1 (local) line or the DS-1/L2 (network) line.
Use the table option to view the status of both lines.

To display the line parameters enter:

CLI> show t1e1 lineParameters table

A sample display is shown below:

`LineIndex`	`:`	`localEnd(T1=DSX-1/E1=L1) (operational)`
	`:`	`localEnd(T1=DSX-1/E1=L1) (configured)`
`Profile`	`:`	`1 (operational)`
	`:`	`1 (configured)`

End Of Topic