Use the following CLI command to display information about the primary netlink:
CLI> show fr tunnel configured table
|
Note: For Passport 4430, 4450, and 4455, the Logical Interface Module (LIM) name for the base module is always limA. The WAN and Expansion modules are numbered lim1 through lim4. For the Passport 4460, the LIM name for the base module is always base, Expansion modules are named exp1, exp2, and the PCMCIA module is named pcmciaExp. |
The first five parameters of the table supply important information about the netlink.
| TunnelIfIndex | The IfIndex assigned to the primary netlink (149) |
| DlciNumber | The DLCI assigned to the primary netlink (16). For information about DLCIs, go to Configure Connections to the Passport Network, Data Link Connection Identifier (DLCI). |
| PhysicalCard | The physical location of the port carrying the primary netlink. |
| PhysicalPort | Primary port - base indicates the base module, and 2 is the port number (Port 2). |
| Type | The type of netlink. The primary netlink is always configured as PANL-DTE (shown as dte-panl in the display). |
|
Note: This configuration (IfIndex 149, Port 2) is typical of Passport 4400 units with at least two configured ports on the base module. For Passport 4400 units with only one base module port available, the default primary port will be Port 1, and the default primary netlink will be assigned an IfIndex of 147. |
Continue on to Default Primary Netlinks.
  |
|