Go back one pageGo to the next page#Go to this book's Table of ContentsGo to this book's Index#

Configurator Procedure for Viewing the Primary Netlink Display Table

  1. To view information about a primary netlink, select Configure, WAN/Data Services, and PANL.

    2. You will see the Port/Channel Selection (PANL) window:

  2. At the top of the window, select the Netlink (Tunnel) link. You will see the Netlinks (Tunnels) window:

  3. Click Modify next to the Tunnel you want to configure. You will see the Modify a Netlink (Tunnel) window:

    4. The Passport 4460's Modify a Netlink (Tunnel) window, also includes the parameter for the DS0 Channel.

The first five parameters in the window supply important information about the netlink.

Index

The IfIndex assigned to the primary netlink (149).

DLCI Number

The DLCI assigned to the primary netlink (16). For information about DLCIs, go to Configure Connections to the Passport Network, Data Link Connection Identifier (DLCI)".

Card Slot

The physical location of the port carrying the primary netlink

Channel

Primary port - base indicates the base module, and 2 is the port number (Port 2).

Type

The type of netlink. The primary netlink is always configured as PANL-DTE (shown as Dte panl in the display).


Note

Note: For Passport 4430, 4450, and 4455, the Logical Interface Module (LIM) name for the base module is always limA. The WAN and Expansion modules are numbered lim1 through lim4. For the Passport 4460, the LIM name for the base module is always base, Expansion modules are named exp1, exp2, and the PCMCIA module is named pcmciaExp.


Continue on to Default Primary Netlinks.

Nortel Networks LogoContact us by email
Go back one pageGo to the next page#Go to this book's Table of ContentsGo to this book's Index