The agingTime subcommand is used to configure an aging time value within the NAS. Periodically, as determined by the HelloTime command previously set, the NAC will issue a Hello signal to the NAS. Each time a Hello signal is received, it is recorded in the NAS. If the time since NAC was last heard from exceeds the aging time, the NAS will purge all DNA map entries belonging to the non-responding NAC.
For example, if the aging time selected is 120, and no Hello signal is received from a given NAC for 120 seconds, all entries belonging to that NAC will be purged from the NAS.
CLI> set nas basic agingTime
| Parameter | Range of Values | Required Action |
|---|---|---|
| <AgingTime> | INTEGER (60..8000) secs | Select a value between 60 and 8000 seconds |
|
Note: All set commands take effect immediately upon entry. They are rolled back after the Passport 4400 unit has been reset, unless saved. |
End of Topic
  |
|