Go back one pageGo to the next page#Go to this book's Table of ContentsGo to this book's Index#

Defining the NAC

Use this command to assign a customer ID and to specify the size of the NAC cache of the local Passport 4400 unit. These commands are not supported by Configurator.

CLI> define nac

customerId

numCacheEntries

CLI> define nac customerId

Parameter

Range of Values

Required Action

<CustomerId>

INTEGER (1..99)

Enter an integer between 1 and 99. This integer will identify the local Passport 4400 unit as belonging to a unique customer group. It will then be able to access only those users who belong to this customer group.


CLI> define nac numCacheEntries

Parameter

Range of Values

Required Action

<NumCacheEntries>

INTEGER (100..1000)

Specify the maximum number of address resolutions to be stored in the cache by entering a number between 100 and 1000.


Note

Note: All Define commands take effect after the changes have been saved and the Passport 4400 unit has been reset.


End of Topic

Nortel Networks LogoContact us by email
Go back one pageGo to the next page#Go to this book's Table of ContentsGo to this book's Index