CLI Procedure for Using the System Action Commands

Parameter	Range of Values	Required Action
<Action>	For Passport 4430/50/55: disconnect \| loopbackTest \| terminateTest \| forceConnect \| reregisterPhoneNumber For Passport 4460: disconnect \| loopbackTest \| terminateTest \| reregisterPhoneNumber	The type of system action you intend to perform. At present, the action involves either starting or stopping loopback tests on all channels. Other actions are: disconnect. Disconnects an existing connection. loopbackTest. Starts a loopback test. terminateTest. Stops the loopback test. forceConnect. Currently not implemented. reregisterPhoneNumber. This action must be performed after changing egress phone numbers, provided that your system uses NAC/NAS for resolving network address locations. Following any restart, reregistration is not required; it is done automatically by the system.

Parameter

Range of Values

Required Action

<Action>

For Passport 4430/50/55:
disconnect | loopbackTest | terminateTest | forceConnect | reregisterPhoneNumber

For Passport 4460:
disconnect | loopbackTest | terminateTest | reregisterPhoneNumber

The type of system action you intend to perform. At present, the action involves either starting or stopping loopback tests on all channels. Other actions are:

disconnect. Disconnects an existing connection.
loopbackTest. Starts a loopback test.
terminateTest. Stops the loopback test.
forceConnect. Currently not implemented.
reregisterPhoneNumber. This action must be performed after changing egress phone numbers, provided that your system uses NAC/NAS for resolving network address locations. Following any restart, reregistration is not required; it is done automatically by the system.