Go back one pageGo to the next page#Go to this book's Table of ContentsGo to this book's Index#

Voice Channel Status (Passport 4460)

To display the channel status for a voice module, use the Configurator procedures below:

  1. Select Status/Statistics, Voice, and Voice from the navigation window.

    2. You will see the Voice Channel Statistics window.

  2. At the top of the window, click on Status. You will see the Voice Channel Status window:

The parameters displayed in the Voice Channel Status window are described below:

Card Slot

Indicates the physical location of the voice card within the Passport 4460 unit.

Channel Number

Indicates the current channel number assigned to the port on the voice card.

Interface Type

Indicates the type of interface card configured for that channel.

Network Connect

Indicates the current network connection status. The possible displays are:

  • Idle
  • call in progress
  • local connected
  • remote connected
  • disconnect in progress
  • not ready

Input Level

Indicates the amplification level for the voice input signal.

Card Type

Indicates the physical card type of the expansion module.

DSP Number

Indicates which DSP is being used for each voice channel.

Time Slot

Indicates the timeslot assigned to the channels in each expansion slot.


Note

Note: For Transparent CCS applications, the T1/E1 line (Interface Type) can be in either CCS or CAS mode, because the D- channel DS0 is bypassed transparently and does not care about the low level CAS/CCS signaling protocol in use.


End Of Topic

Nortel Networks LogoContact us by email
Go back one pageGo to the next page#Go to this book's Table of ContentsGo to this book's Index