Go back one pageGo to the next page#Go to this book's Table of ContentsGo to this book's Index#

Configurator Procedure for Enabling or Disabling Traps

  1. Complete Step 1 in Configurator Procedure for Viewing and Enabling System Trap Status.
  2. Click the applicable radio button (Enable or Disable) next to the desired trap.
  3. Click Save. A "Command Successful" appears.

    4. You must save the configuration and reset the system. Go to Save the Current Configuration and Reset the Unit.

End of Procedure

Frame Relay Line Parameters

CLI Procedure for Configuring and Displaying Frame Relay System Parameters

Nortel Networks LogoContact us by email
Go back one pageGo to the next page#Go to this book's Table of ContentsGo to this book's Index