The following SVC parameters are used to set traffic management parameters, which define traffic flow on a specific SVC.
|
Note: You must enable Global TM rateEnforcement before any of the parameters below will have any effect. Refer to Traffic Management. |
To configure frame relay SVC parameters, use the following CLI command:
CLI> define fr switch svc
discardPriority
dna
holdingPriority
maxRxBurstSize
maxRxSize
maxTxBurstSize
maxTxSize
rxExcessBurstSize
maxrxThroughput
setupPriority
txExcessBurstSize
txPriority
maxtxThroughput
For each of the above SVC parameters, you must enter the ConnectID for the SVC.
Configuring Frame Relay SVC Parameters Using the CLI
  |
|