Go back one pageGo to the next page#Go to this book's Table of ContentsGo to this book's Index#

Configurator Frame Relay PVC Parameters

  1. To configure frame relay PVC parameters, select Configure, WAN/Data Services, and FR DCE.

    2. You will see the Port Selection window.

  2. At the top of the window, select the PVC Endpoint link. You will see the PVC EndPoint Configuration window:

  3. Configure the PVC Parameters described below:

    4. Parameter

    Required Actions

    Max. Rx Frame Size

    Enter the maximum frame size in bytes that will be accepted on this DLCI.

    Max. Tx Frame Size

    The maximum frame size in bytes that will be transmitted on this DLCI. The range is from 0 to 4096. The default value is 1600.

    Committed Excess Size (Rx)

    The maximum burst size (temporary data rate above the CIR) in bits per second (b/s) that will be accepted on this DLCI. The range is from 0 to 2560000 b/s. The default is 0. Currently not implemented on the Passport 4400.

    Committed Excess Size (Tx)

    The maximum burst size (temporary data rate above the CIR) in bits per second (b/s) that will be transferred on this DLCI. The range is from 0 to 2560000 b/s. The default is 0. Currently not implemented on the Passport 4400.

    Rx CIR

    The data rate in b/s that the network agrees to deliver on this DLCI. The range is from 0 to 2560000 b/s. The default is 64000.

    Tx CIR

    The estimated data rate in b/s that the device on this DLCI will deliver to the network; the committed bandwidth to be allocated. The range is from 0 to 2560000 b/s. The default is 64000.


Configurator Frame Relay SVC Parameters

Nortel Networks LogoContact us by email
Go back one pageGo to the next page#Go to this book's Table of ContentsGo to this book's Index