Configurator Procedure for Defining Multiple Frame Relay Switch Maps

Use the procedure below for define multiple frame relay Switch maps as illustrated as shown in Defining Multiple Frame Relay Switch Maps.

1. To define multiple frame relay switch maps, select Configure, WAN/Data Services, and FR DCE.



You will see the Port Selection window.

2. Select the port you want to configure. You will see the FR DCE Signaling Protocol Configuration window:



3. Use the pull down menu to select the applicable LMI Type.
4. Click Save. A "Command Successful" appears.
5. Click Next. You will see the Add a Switch Map Entry (FR DCE) window:



6. Use this window to add switch maps for sites 1 through 4. Refer to page 187 through page 191 for example switch map configurations.