Auto Ringdown (Analog Only)

The autoRingDown subcommand operates in conjunction with Hoot and Holler. When Auto Ringdown (ARD) is configured, and the line goes off-hook, the far end rings immediately. This function operates opposite of Auto Call where the call setup is delayed due to the time it takes to dial the far-end number. The connection between the two parties remains permanently up regardless of whether either party is talking or not or until both sides go on-hook.

Configuring ARD

Configuring ARD on the Master and Slave sides requires the following:

The proper egress table entries should be made as detailed in the section titled Egress Table.
Hoot and Holler should be configured as described starting in Hoot-and-Holler.
Enable ARD using the following subcommand:

CLI> set voice switchingprofile autoRingDown

Parameter	Range of Values	Required Action
<Profile>	Passport 4430/50/55 INTEGER (1..32) Passport 4460 INTEGER (1..60)	Enter the number of the switching profile you are configuring. For this example, assume that this is profile number 1.
<AutoRingDown>	disable \| enable	Enter enabled

Parameter

Range of Values

Required Action

<Profile>

Passport 4430/50/55
INTEGER (1..32)

Passport 4460
INTEGER (1..60)

Enter the number of the switching profile you are configuring. For this example, assume that this is profile number 1.

<AutoRingDown>

disable | enable

Enter enabled

End of Topic