Go back one pageGo to the next page#Go to this book's Table of ContentsGo to this book's Index#

Address Server Selection

The addServerSelect subcommand specifies which DNA server is to be used for network address resolution: NAS or VNCS.

Using the Address Server Subcommand

To access the addServerSelect subcommand, enter:

CLI> set voice switchingProfile addServerSelect

Parameter

Range of Values

Required Action

<Profile>

Passport 4430/50/55
INTEGER (1..32)

 

Passport 4460
INTEGER (1..60)

Enter the number of the switching profile you are configuring.

<addServerSelect>

nas | vncs

Choose the parameter that meets the requirements of your system: nas, if your DNA server is a Passport 4400 unit; vncs, if your DNA server is a Passport 6400 unit.


Nortel Networks LogoContact us by email
Go back one pageGo to the next page#Go to this book's Table of ContentsGo to this book's Index