Add a PANL Netlink

1. On the PVC LMI (PANL) window, click Next. You will see the Add a PANL Netlink (Tunnel) window:



See the table below for a description of the required parameters:

Parameter	Range of Values	Required Actions
DLCI Number	INTEGER (16 - 991)	The DLCI is used to identify this netlink when passing frame relay (and PANL) traffic. For connections across a public frame relay network, consult your network administrator for this value.
Type	dte-panl, dce-panl, standard	Choose standard for frame relay traffic (RFC 1490) between a Passport 4400 and a third party FRAD or router. Choose dte-panl or dce-panl to specify PANL netlinks between Passport units.
Passport 4460: Physical Channel	INTEGER (-1..30)	For frame relay enter -1. If you are channelizing (DACS) for the T1 parameter, go to Digital Access and Cross-Connect System (DACS) for the applicable value.



2. Click Save. "Command Successful" appears.

You must reset the system before the new configuration will take effect. Go to Save the Current Configuration and Reset the Unit for the steps necessary to save your new configuration.