Configurator Procedure for Input of Committed Information Rate (CIR) Data

The following Configurator procedure is used to input CIR data to an existing netlink:

1. Under WAN/Data Services, select PANL. You will see the Port Selection (PANL) window. At the top of the page, select the Netlink (Tunnel) link. You will see the Netlinks (Tunnels) window.
2. Click Modify next to the netlink you want to configure. You will see the Modify a Netlink (Tunnel) window:



The Passport 4460 Modify a Netlink (Tunnel) window displays Port and DS0 Channel parameters.

3. The parameters that you need to configure for CIR data are:
• Max Rx CIR
• Max Tx CIR



4. Rx CIR field: Enter the maximum receive CIR (in bits/sec) for this PVC tunnel.
5. Tx CIR field: Enter the maximum transmit CIR (in bits/sec) for this PVC tunnel.

Note: Maximum receive/transmit is the maximum receive/transmission rate of the frame size sent out through the PVC tunnel.



6. Click Save. A "Command Successful" appears.

You must reset the system before the new configuration will take effect. See Save the Current Configuration and Reset the Unit for the steps necessary to save your new configuration.

End of Procedure

End of Topic

End of Configurator procedures for Configure Passport Connections

CLI Commands for Netlink Parameter Configuration