Use the following Configurator procedure to input variables for the PANL-DTE connection:
You will see the Port Selection (PANL) window.
The table below describes the required parameters:
| Parameter | Range of Values | Required Action |
|---|---|---|
| Sub-Channel DLCI | INTEGER (17 - 255) | Enter the maximum number of DLCI you want configured for the Passport 4400 unit. The default for this parameter is 47 (63-16). If you think that you will need more than 47 DLCIs, change this parameter to fit your needs. |
| DTE Rx Bandwidth | INTEGER (16000 - 204800) | Enter the same value that the CIR parameter of the Passport 4400 unit is set to. See Configurator Procedure for Input of Committed Information Rate (CIR) Data. |
| DCE Rx Bandwidth | INTEGER (16000 - 204800) | Enter the same value that the CIR parameter of the Passport 4400 unit is set to. Configurator Procedure for Input of Committed Information Rate (CIR) Data. |
| Max. DTE Frame Size | INTEGER (50 - 4100) | Enter the maximum size (in bytes) of frames received by the PANL-DTE. To ensure proper flow of voice packets, set these parameters to (baud/64000) * 80, where baud is the baud rate of the physical WAN port as selected in Step 4 of Configurator Procedure for Configuring Physical Ports and DLCIs. |
| Max. DCE Frame Size | INTEGER (50 - 4100) | Enter the maximum size (in bytes) of frames received by the PANL-DTE. To ensure proper flow of voice packets, set these parameters to (baud/64000) * 80, where baud is the baud rate of the physical WAN port as selected in Step 4 of Configurator Procedure for Configuring Physical Ports and DLCIs. |
You must reset the system before the new configuration will take effect. Go to Save the Current Configuration and Reset the Unit for the steps necessary to save your new configuration.
Configurator Procedure for Input of Committed Information Rate (CIR) Data
  |
|
