Add an ISDN Peer Entry

1. If necessary, repeat Steps 1 through 4 from Displaying Configured ISDN Peer Entries.
2. Locate the Peer ID field, enter a unique Peer ID number for the ISDN Service. Refer to the table displayed above and select a Peer ID number that is not in use.

Note: It is recommended that the new ID number be higher than the existing ID numbers. For example, in the above display IDs 1 through 4 are in use, so use the number 5 for this ISDN service.



3. Enter the IfIndex number which corresponds to the physical interface type you are adding (for example, isdnu or isdns).
4. Once you have entered the parameters, click Add. You will see the Configure ISDN Service - Dial Control Peer - ADD window:



5. Locate the B channel field. Set the variable to "1".

Note: This command applies to leased lines only (not public ISDN networks).



6. Locate the Originate Address field. Enter the destination telephone number.
7. Locate the Sub Address field. Enter the sub address of the destination telephone number.
8. Click Add. A "Command Successful" appears.

You must reset the system before the new configuration will take effect.

Continue on to Save the Current Configuration and Reset the Unit