Configurator Procedure for Creating SPVCs

Note: Switched permanent virtual circuit (SPVC) refers to a connection between a Passport 4400 unit and a Passport 6400 unit, or between two Passport 4400 units. SPVCs eliminate the need to configure each node along the connection. The end point is configured, but the connection route is selected automatically.

1. Select Configure, Protocols, Virtual Circuits, and SPVCs.



You will see the SPVC Table window.

2. At the top of the window click on Add SPVC. You will see the Add a SPVC window:



See the table below for a description of the required parameters:

Parameter	Range of Values	Required Action
Virtual Port IfIndex	INTEGER (1..255)	Enter the virtual port associated with the DNA.
Local DLCI	INTEGER (16-991	Enter the DLCI number on the local DCE interfaces.
Remote DLCI	INTEGER (16.991)	Enter the DLCI number on the remote DCE interface.
Remote DNA	Frame Relay DNA	Enter the DNA prefix of the associated virtual port. Be sure to enclose the string in quotes without any spaces.
Connection Type	Slave, Master	Enter which side of the SPVC segment will initiate the call.



3. Enter the above parameters and click Save. A "Command Successful" appears.
4. You must save the configuration. Complete the steps in Save and Reset the Current Configuration.

End of Procedure

End of Topic

End of Configurator procedures for About IP Priority Traffic

CLI Procedure for Creating SVCs

CLI Procedure for Creating SPVCs