Configurator Procedure for Configuring SVCs

Use the following procedure to create SVCs for IP prioritization and filtering:

1. Select Configure, Protocols, Virtual Circuits, and SVCs.



You will see the SVC Table window.

2. At the top of the window click Add a SVC. You will see the Add a SVC window:



See the table below for a description of the above required parameters:

Parameter	Range of Values	Required Actions
Remote DNA Address	Frame Relay DNA (1..34)	Enter the local DNA string of the Virtual Port.
Virtual Port Index	INTEGER (1..255)	Enter the local virtual port.
Transfer Priority	INTEGER (0..15)	This value determines the priority of the traffic on the SVC. Enter a value between 0 and 15, with higher numbers indicating a higher priority.



3. Enter the above parameters and click Add. A "Command Successful" appears.

You must reset the system before the new configuration will take effect.

Continue on to Save and Reset the Current Configuration

Note: The choice of which device is the master and which device is the slave is by convention. It is recommended that in the Passport 4400-to-Passport 6400 connection, the Passport 4400 be designated the master for the purpose of speedier service recovery.