Configurator Procedure for IP Forwarding System

1. Select Configure, Protocols, IP, IP Filtering, and System. You will see the IP System Filter window.



2. At the top of the window, click Add Filter. You will see the Add an IP System Filter window:



The table below describes the above required parameters:

Parameter	Range of Values	Required Actions
Destination Mask	IPAddress	Enter the IP address of the destination filter mask.
Destination Address	IPAddress	Enter the IP address of the destination IP filter address.
Source Mask	IPAddress	Enter the IP address of the source filter mask.
Source Address	IPAddress	Enter the IP address of the source IP filter address.
Protocol ID	INTEGER (1.255)	Enter the INTEGER(s) that represent the correct protocol type for this Passport 4400.
Port Id	INTEGER (1..65535)	Enter the INTEGER(s) that represent the Port ID.
Priority	Low, Medium, High	This value determines the priority of the traffic on this filter
Filter Action	Forward | Discard	This command determines the nature of the filter.The filter's Action determines the nature of the filter. Discard blocks transmissions as specified in the filter masks and addresses. Forward seeks out information with the specified masks and addresses, and then passes (forwards) the information to its destination, blocking all other information.
Order	INTEGER (1..255)	This value determines the filter order in the filter table.

You must define the above parameters for both the Master and Slave sides of the connection, and any other router used in the network for filtering.

For system filtering, both the destination and source must be specified.

End of Procedure

End of Topic

Configurator Procedure for Configuring SVCs

CLI Procedure for IP Forward Filter