Continued from step 2.

3. Set the Passport unit to IP routing.

Select Configure and System from the navigation menu:



Then, select Bridge/Route. You will see the Bridge/Routing Parameters screen. Select Routing and click on the Save button, as follows:



4. Turn on RIP (Routing Information Protocol).

Select Configure, Protocols, IP, and RIP from the navigation menu:



The RIP Parameters screen will be displayed. Make the necessary selections from this screen, be sure to select On for RIP Enable, and click on the Save button:



5. Define the NAC server.

Select Configure, System, and NAC Server from the navigation menu:



You will see the NAC Server screen. Click on the Add a NAC Server link at the top of this screen. The Add a NAC Server screen will be displayed:



Fill in the fields as follows:

• IP Address: enter the IP address to be added to the NAC server (same IP address as assigned to the Passport unit for VoIP).
• Name: enter a name (up to 50 alphanumeric characters) to identify this entry in the NAC server.
• Type: select Primary.

Click on the Add button.

Continue on to step 6.