You can use the following commands using the CLI to view the parameter settings of VoIP. (The Configurator Voice Over IP Services screen, Configure -> Voice -> V/IP, displays the VoIP channel configurations.)
CLI> show voice vip table
The VoIP parameter settings for all the entries will be displayed similar to the following example:
You can use the following command to view the VoIP parameter settings for a single IP address:
CLI> show voice vip entry
| Parameter | Range of Values | Required Action |
|---|---|---|
| <Address> | IP address (n.n.n.n) | Enter the associated IP address of the Passport unit for which you want to view VoIP parameters. |
Example:
The following command will display the active default transport method for calls to the voice channels on the local Passport:
CLI> show voice transMethod
Example:
  |
|