show hpip virtualPort (configured/operational) (entry/table)

Use show hpip virtualPort to display the High Performance IP (HPIP) virtual port. This command allows you to view the virtual ports for the HPIP links over the WAN. The Link Control Protocol (LCP) and Network Control Protocol (NCP) states of the HPIP link are displayed. When both are in an opened state, this indicates that the hpip link is up. Information for the virtual port for the console is not displayed with this command. If you need to display the PPA entry for the console port, issue a show system interfaceExtension command.

You must enter the Index in order to display an individual entry: (One entry is shown when you use the entry option and the full table of entries is shown when you use the table option.)

IfIndex	WanPort	Enable	Mode	LCPState	NCPState
6	150	enable	listen	opened	opened
100	153	enable	listen	closed	closed

IfIndex	Indicates the IfIndex of the virtual port.
WanPort	Indicates the IfIndex of the WAN port on the Passport 4400 unit that is being used for the HPIP link.
Enable	Indicates that the hpip virtual port is enabled or disabled.
Mode	This specifies the mode of the virtual port. Call indicates that the virtual port will make the connection. Listen indicates that the virtual port will listen for incoming connections.
LCPState	Indicates the LCP state of the PPP connection over this HPIP virtual port. The LCP is used to establish, configure, and test the data link connection.
NCPState	Indicates the NCP state of the (Point-to-Point Protocol) PPP connection over this HPIP virtual port. The NCP is used to establish and copnfigure different network layer protocols.

Object	Parameter
<IfIndex>	: INTEGER (1..255)