Go back one pageGo to the next page#Go to this book's Table of ContentsGo to this book's Index#

show x25 connection (entry/table)

Use show x25 clearedConn to display information on the X.25 connections for the active call list. LCNs, connection state, type of connection, call parameter index, start time, octets, packets, interrupts, and resets are shown. Refer to Configuring and Operating Passport 4400 Software, Data Services, X.25 Services, Administering the X.25 Services, CLI Administration Functions, X.25 Show Commands for more detailed information about this command.

You must enter the Id in order to display an individual entry: (One entry is shown when you use the entry option and the full table of entries is shown when you use the table option.)

Object

Parameter

<Id>

: INTEGER (1..255)


A table similar to the following is displayed:

Id

:8

Source

:182

SourceLCN

:18

Destination

:52

DestinationLCN

:1

State

:active

Type

:svc

CallParmIndex

:8

StartTime

:00Years 001Days 20:51:12

OrigOctets

:0

DestOctets

:0

OrigPackets

:0

DestPackets

:0

OrigInterrupts

:0

DestInterrupts

:0

OrigResets

:0

DestResets

:0

Id

Connection Identifier that uniquely identifies a connection on this interface

Source

The ifIndex of source X.25 port.

SourceLCN

Identifies the specific destination X.25 layer 3, SVC or PVC connection number.

Destination

The ifIndex of destination X.25 port.

DestinationLCN

Identifies the specific X.25 layer 3, PVC or SVC connection number.

State

Current connection state; 'out-of-order' applies to PVCs only and 'pending' and 'clearing' apply to SVCs only.

Type

Indicates the type of connection; either switched (SVC) or permanent (PVC).

CallParmIndex

Reference to call parameters in the call parameter table.

StartTime

Stores the system time tick at the moment the connection was created.

OrigOctets

Contains the number of data octets received from the calling DTE.

DestOctets

Contains the number of data octets received from the called DTE.

OrigPackets

Contains the number of data packets received from the calling DTE.

DestPackets

Contains the number of data packets received from the called DTE.

OrigInterrupts

This object contains the number of interrupt packets received from the calling DTE.

DestInterrupts

This object contains the number of interrupt packets received from the called DTE.

OrigResets

This object contains the number of reset packets received from the calling DTE.

DestResets

This object contains the number of reset packets received from the called DTE.


Nortel Networks LogoContact us by email
Go back one pageGo to the next page#Go to this book's Table of ContentsGo to this book's Index