set t1e1 profile (Passport 4430/4450/4455 units)

Use set t1e1 profile to set a profile of T1/E1 line parameters. Profiles can be set for either local or network T1/E1 lines.

You must enter the profile number :INTEGER (1..2) for each of the following objects:

Object	Parameter	Description
<e1CRC4Status>	: disable \| enable	Enables the CRC-4 cyclic redundancy check feature. When enabled, the E1 Access Module generates and monitors for the CRC algorithm carried on bit 1 of timeslot 0 of an E1 frame.
<e1LineCode>	: ami \| hdb3	Selects either AMI or HDB3 line code. ami indicates that HDB3 suppression is disabled. When AMI is selected, you must ensure that the Data Terminal Equipment is generating at lease one 1 in every four bits. hdb3 (High Density Bipolar 3), a ITU-TSS-recommended coding method which limits the maximum number of consecutive zeros to three.
<e1TS16Connection>	: toCAS \| idle \| bypass \| toDataPort1\| toDataPort2	Specifies the signaling system to be used in time slot 16. toCAS supports G.704 channel associated signaling. In this method, a multiframe structure of 16 consecutive frames numbered 0 through 15 is used. In each frame, time slot 16 allocates four bits to two channels in the following pattern: Frame 0 = multiframe alignment; Frame 1 = ABCD of Ch 1 and ABCD of Ch 16; frame 2 = ABCD of Ch 2 and ABCD of Ch 17; etc., up to frame 15.
<idleCode>	: INTEGER (0..255)	Sets the idle code for the DS0 channels. Values range from 0 to 255. Specify the profile number (1 or 2).
<t1BuildOut>	: lessThan110feet \| lessThan220feet \| lessThan330feet \| lessThan440feet \| externalLBO \| greaterThan665feet\| lessThan550feet \| lessThan660feet	Specifies cable length attached to the line. Specify the profile number (1 or 2).
<t1FrameFormat>	: superFrame(D4) \| extendedSuperFrame(ESF)	Sets the profile for either superframe (D4) or extended superframe (ESF). Superframe consists of 12 frames and extended superframe consists of 24 frames.
<t1LineCode>	: ami \| b8zs	Sets either AMI or B8ZS zero suppression. AMI disables B8ZS suppression; however, a bit density requirement is created which can be satisfied by assuring that the DTE is generating at least one 1 in every byte. Voice is not affected as PCM code does not allow bytes without a 1.
<t1LoopbackStatus>	: disable \| enable	Used to enable T1 network-invoked loopback tests. When enabled, the T1 Access Module recognizes and responds to network-invoked loopback commands. When disabled, the T1 Access Module will not respond to network-invoked loopback commands.