Go back one pageGo to the next page#Go to this book's Table of ContentsGo to this book's Index#

Logging into and out of the CLI

  1. Press the Enter key several times until you receive the following prompt:

    2. login:

  2. At the login prompt, enter the following command:

    3. cli

    The Passport 4400 unit will then prompt you for a password.

    Note

    Note: The default password for a Passport 4400 unit is a carriage return. (Type the Enter key.) However, your system administrator may have implemented a password scheme using the set system communityString command. Try typing the Enter key at the password prompt. If this does not work, contact your system administrator for a password.


  3. At the password prompt, press the Enter key. If this does not work, enter the password defined by your system administrator. The Passport 4430/4450/4455 unit will respond with the following message:

    4. Welcome to the Passport 4400 Series Command Line Interface

    Nortel Networks Communication Corporation

    CLI>

    The Passport 4460 unit will respond with the following message:

    Welcome to the Passport 4460 Command Line Interface

    Nortel Networks Communication Corporation

    CLI>

Once you receive the CLI> prompt, you can begin to enter the commands used to configure the Passport 4400 unit.

  1. Exit the CLI utility by entering the following command:

    2. logout

Nortel Networks LogoContact us by email
Go back one pageGo to the next page#Go to this book's Table of ContentsGo to this book's Index