Use define hpip virtualPort to make changes to a hpip virtual port. These commands are not dynamic, so if the hpip port does not exist, these commands will fail.
Note: define hpip virtualPort is not a dynamic command so you must reset the Passport 4400 unit for the command to take effect.
Object
Parameter
Description
<IfIndex>
:INTEGER (1..255)
This is an index value that identifies the virtual port.
<WanPort>
INTEGER (1..255)
Defines the WAN port that the hpip virtual port is connected to.
<Enable>
:enable | disable
Choose enable to use the hpip virtual port. Choose disable if you are not going to use the port. If the port is disabled, calls cannot be made or received.
<Mode>
:call | listen
Choose call to change the hpip virtual port to initiate calls. Choose listen to change the hpip virtual port to listen for calls.
