Add Commands

Use the add command to add network components and services to a table. Use add to place new entries into a table. Values programmed using the add command will take effect once they have been saved and the system has been reset.

Exception: When provisioning bridge filters, the add command takes effect dynamically. In this case, a save configuration update is required if the change is to be retained after a reset. After you enter the command string and parameters, execute a save configuration update command and a reset system current reset in order for them to take effect.The following is a list of services available to you with add:

Note: You do not have to execute a reset system current reset after you use the add ip route command. The Passport 4400 unit is updated dynamically when you use this command.

Note: The parameter "IfIndex" is used in many of the CLI commands. For a detailed explanation of IfIndexes, refer to Getting Started, IfIndexes and Interface Identification, IfIndex Overview.